upstream u-boot with additional patches for our devices/boards: https://lists.denx.de/pipermail/u-boot/2017-March/282789.html (AXP crashes) ; Gbit ethernet patch for some LIME2 revisions ; with SPI flash support
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
u-boot/board/Marvell/common/bootseq.txt

95 lines
2.0 KiB

(cpu/mpc7xxx/start.S)
start:
b boot_cold
start_warm:
b boot_warm
boot_cold:
boot_warm:
clear bats
init l2 (if enabled)
init altivec (if enabled)
invalidate l2 (if enabled)
setup bats (from defines in config_EVB)
enable_addr_trans: (if MMU enabled)
enable MSR_IR and MSR_DR
jump to in_flash
in_flash:
enable l1 dcache
gal_low_init: (board/evb64260/sdram_init.S)
config SDRAM (CFG, TIMING, DECODE)
init scratch regs (810 + 814)
detect DIMM0 (bank 0 only)
config SDRAM_PARA0 to 256/512Mbit
bl sdram_op_mode
detect bank0 width
write scratch reg 810
config SDRAM_PARA0 with results
config SDRAM_PARA1 with results
detect DIMM1 (bank 2 only)
config SDRAM_PARA2 to 256/512Mbit
detect bank2 width
write scratch reg 814
config SDRAM_PARA2 with results
config SDRAM_PARA3 with results
setup device bus timings/width
setup boot device timings/width
setup CPU_CONF (0x0)
setup cpu master control register 0x160
setup PCI0 TIMEOUT
setup PCI1 TIMEOUT
setup PCI0 BAR
setup PCI1 BAR
setup MPP control 0-3
setup GPP level control
setup Serial ports multiplex
setup stack pointer (r1)
setup GOT
call cpu_init_f
debug leds
board_init_f: (common/board.c)
board_early_init_f:
remap gt regs?
map PCI mem/io
map device space
clear out interupts
init_timebase
env_init
serial_init
console_init_f
display_options
initdram: (board/evb64260/evb64260.c)
detect memory
for each bank:
dram_size()
setup PCI slave memory mappings
setup SCS
setup monitor
alloc board info struct
init bd struct
relocate_code: (cpu/mpc7xxx/start.S)
copy,got,clearbss
board_init_r(bd, dest_addr) (common/board.c)
setup bd function pointers
trap_init
flash_init: (board/evb64260/flash.c)
setup bd flash info
cpu_init_r: (cpu/mpc7xxx/cpu_init.c)
nothing
mem_malloc_init
malloc_bin_reloc
spi_init (r or f)??? (CFG_ENV_IS_IN_EEPROM)
env_relocated
misc_init_r(bd): (board/evb64260/evb64260.c)
mpsc_init2