You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
|
|
|
|
altbootcmd=run ${subbootcmds}
|
|
|
|
|
bootcmd=run ${subbootcmds}
|
|
|
|
|
configure=run set_uimage; km_setboardid && saveenv && reset
|
|
|
|
|
subbootcmds=tftpfdt tftpkernel nfsargs add_default boot
|
|
|
|
|
nfsargs=setenv bootargs root=/dev/nfs rw nfsroot=${serverip}:${toolchain}/${arch}
|
arm/km: define fdt_high env variable and allow backwards compatibility
Add set_fdthigh subcommand to "subbootcmds" (release) so to set "fdt_high"
This is necessary on Kirkwood so that the FDT does not get relocated
above the memory limit that the kernel cannot access
(that is the memory part reserved for the switch).
This was tested on NUSA1, where it is necessary, and on ETER1, where it
doesn't seem to hurt.
We want the scripts to also work with older versions of u-boot, where:
a) set_fdthigh is not defined (will be default env for newer u-boots)
b) the fdt will not be available
For this reason, we use "set_fdthigh" to tell whether we are running
a newer (FDT-aware) u-boot or not.
So if "set_fdthigh" runs successfully or arch != arm we try loading
the fdt; otherwise we proceed normally.
Notice how, contrary to release mode, set_fdthigh will _not_ be part of
subbootcmds for develop and ramfs, but will be executed as part of
"tftpfdt".
Since this is only needed for kirkwood cards, and it prevents the kernel
from booting on QorIQ (though it seemed to work on ETER1), we change
its definition in the default env for powerpc so that the value is only
set on ARM.
Signed-off-by: Valentin Longchamp <valentin.longchamp@keymile.com>
Signed-off-by: Gerlando Falauto <gerlando.falauto@keymile.com>
Signed-off-by: Holger Brunck <holger.brunck@keymile.com>
Acked-by: Valentin Longchamp <valentin.longchamp@keymile.com>
11 years ago
|
|
|
tftpfdt=if run set_fdthigh || test ${arch} != arm; then tftpboot ${fdt_addr_r} ${hostname}/${hostname}.dtb; else true; fi
|
|
|
|
|
tftpkernel=tftpboot ${load_addr_r} ${hostname}/${uimage}
|
|
|
|
|
toolchain=/opt/eldk
|
|
|
|
|
rootfssize=0
|
|
|
|
|
set_uimage=printenv uimage || setenv uimage uImage
|
