Enabled the Freescale SGMII riser card on 8536DS

Signed-off-by: Jason Jin <Jason.jin@freescale.com>

board/freescale/mpc8536ds/mpc8536ds.c

@@ -35,8 +35,11 @@
 #include <libfdt.h>
 #include <spd_sdram.h>
 #include <fdt_support.h>
+#include <tsec.h>
+#include <netdev.h>
 
 #include "../common/pixis.h"
+#include "../common/sgmii_riser.h"
 
 #if defined(CONFIG_DDR_ECC) && !defined(CONFIG_ECC_INIT_VIA_DDRCONTROLLER)
 extern void ddr_enable_ecc(unsigned int dram_size);
@@ -618,6 +621,45 @@ int is_sata_supported(void)
 	return 1;
 }
 
+int board_eth_init(bd_t *bis)
+{
+#ifdef CONFIG_TSEC_ENET
+	struct tsec_info_struct tsec_info[2];
+	volatile ccsr_gur_t *gur = (void *)(CONFIG_SYS_MPC85xx_GUTS_ADDR);
+	int num = 0;
+	uint sdrs2_io_sel =
+		(gur->pordevsr & MPC85xx_PORDEVSR_SRDS2_IO_SEL) >> 27;
+
+#ifdef CONFIG_TSEC1
+	SET_STD_TSEC_INFO(tsec_info[num], 1);
+	if ((sdrs2_io_sel == 4) || (sdrs2_io_sel == 6)) {
+		tsec_info[num].phyaddr = 0;
+		tsec_info[num].flags |= TSEC_SGMII;
+	}
+	num++;
+#endif
+#ifdef CONFIG_TSEC3
+	SET_STD_TSEC_INFO(tsec_info[num], 3);
+	if (sdrs2_io_sel == 4) {
+		tsec_info[num].phyaddr = 1;
+		tsec_info[num].flags |= TSEC_SGMII;
+	}
+	num++;
+#endif
+
+	if (!num) {
+		printf("No TSECs initialized\n");
+		return 0;
+	}
+
+	if ((sdrs2_io_sel == 4) || (sdrs2_io_sel == 6))
+		fsl_sgmii_riser_init(tsec_info, num);
+
+	tsec_eth_init(bis, tsec_info, num);
+#endif
+	return pci_eth_init(bis);
+}
+
 #if defined(CONFIG_OF_BOARD_SETUP)
 void
 ft_board_setup(void *blob, bd_t *bd)

include/configs/MPC8536DS.h

@@ -427,6 +427,9 @@ extern unsigned long get_board_ddr_clk(unsigned long dummy);
 #define CONFIG_TSEC3	1
 #define CONFIG_TSEC3_NAME	"eTSEC3"
 
+#define CONFIG_FSL_SGMII_RISER	1
+#define SGMII_RISER_PHY_OFFSET	0x1c
+
 #define TSEC1_PHY_ADDR		1	/* TSEC1 -> PHY1 */
 #define TSEC3_PHY_ADDR		0	/* TSEC3 -> PHY0 */