at91: Enabeling USB host on meesc board

There was an redesign, so USB is available now.

Signed-off-by: Daniel Gorsulowski <Daniel.Gorsulowski@esd.eu>
Signed-off-by: Reinhard Meyer <u-boot@emk-elektronik.de>

board/esd/meesc/meesc.c

@@ -253,7 +253,8 @@ int board_init(void)
 	/* Peripheral Clock Enable Register */
 	writel(1 << AT91SAM9263_ID_PIOA |
 		1 << AT91SAM9263_ID_PIOB |
-		1 << AT91SAM9263_ID_PIOCDE,
+		1 << AT91SAM9263_ID_PIOCDE |
+		1 << AT91SAM9263_ID_UHP,
 		&pmc->pcer);
 
 	/* initialize ET1100 Controller */
@@ -275,5 +276,8 @@ int board_init(void)
 #ifdef CONFIG_AT91_CAN
 	at91_can_hw_init();
 #endif
+#ifdef CONFIG_USB_OHCI_NEW
+	at91_uhp_hw_init();
+#endif
 	return 0;
 }

include/configs/meesc.h

@@ -84,11 +84,11 @@
 #undef CONFIG_CMD_FPGA
 #undef CONFIG_CMD_LOADS
 #undef CONFIG_CMD_IMLS
-#undef CONFIG_CMD_USB
 
 #define CONFIG_CMD_PING				1
 #define CONFIG_CMD_DHCP				1
 #define CONFIG_CMD_NAND				1
+#define CONFIG_CMD_USB				1
 
 /* LED */
 #define CONFIG_AT91_LED				1
@@ -132,6 +132,17 @@
 #define CONFIG_NET_RETRY_COUNT			20
 #undef CONFIG_RESET_PHY_R
 
+/* USB */
+#define CONFIG_USB_ATMEL
+#define CONFIG_USB_OHCI_NEW			1
+#define CONFIG_DOS_PARTITION			1
+#define CONFIG_SYS_USB_OHCI_CPU_INIT		1
+#define CONFIG_SYS_USB_OHCI_REGS_BASE		0x00a00000
+#define CONFIG_SYS_USB_OHCI_SLOT_NAME		"at91sam9263"
+#define CONFIG_SYS_USB_OHCI_MAX_ROOT_PORTS	2
+#define CONFIG_USB_STORAGE			1
+#define CONFIG_CMD_FAT				1
+
 #define CONFIG_SYS_LOAD_ADDR			0x22000000 /* load address */
 
 #define CONFIG_SYS_MEMTEST_START		PHYS_SDRAM