OMAP3: DIG297: Use generic MMC driver

Switch from the legacy omap3 mmc driver to the new generic omap hsmmc
driver.  This patch is based on the work done for Beagle, etc.

Signed-off-by: Tom Rini <trini@ti.com>
Signed-off-by: Sandeep Paulraj <s-paulraj@ti.com>

board/comelit/dig297/dig297.c

@@ -37,6 +37,7 @@
 #include <netdev.h>
 #include <twl4030.h>
 #include <asm/io.h>
+#include <asm/arch/mmc_host_def.h>
 #include <asm/arch/omap3-regs.h>
 #include <asm/arch/mux.h>
 #include <asm/arch/mem.h>
@@ -145,6 +146,14 @@ void set_muxconf_regs(void)
 	MUX_DIG297();
 }
 
+#ifdef CONFIG_GENERIC_MMC
+int board_mmc_init(bd_t *bis)
+{
+	omap_mmc_init(0);
+	return 0;
+}
+#endif
+
 #ifdef CONFIG_CMD_NET
 /*
  * Routine: setup_net_chip

include/configs/dig297.h

@@ -97,8 +97,9 @@
 #define CONFIG_BAUDRATE			115200
 #define CONFIG_SYS_BAUDRATE_TABLE	{4800, 9600, 19200, 38400, 57600,\
 					115200}
-#define CONFIG_MMC
-#define CONFIG_OMAP3_MMC
+#define CONFIG_GENERIC_MMC		1
+#define CONFIG_MMC			1
+#define CONFIG_OMAP_HSMMC		1
 #define CONFIG_DOS_PARTITION
 
 /* DDR - I use Micron DDR */