rockchip: pinctrl: rk3328: use gpio instead of sdmmc-pwren

SDMMC-PWREN is a pin to control voltage for SDMMC IO, it may
be high active or low active, the dwmmc driver always assume
the sdmmc-pwren as high active.

Kernel treat this pin as fixed regulator instead of a pin from
controller, and then it can set in dts file upon board schematic,
that's a good solution, we can also do this in u-boot.

Signed-off-by: Kever Yang <kever.yang@rock-chips.com>
Acked-by: Simon Glass <sjg@chromium.org>
Acked-by: Philipp Tomsich <philipp.tomsich@theobroma-systems.com>
Reviewed-by: Philipp Tomsich <philipp.tomsich@theobroma-systems.com>

drivers/pinctrl/rockchip/pinctrl_rk3328.c

@@ -184,13 +184,11 @@ static void pinctrl_rk3328_sdmmc_config(struct rk3328_grf_regs *grf,
 		if (com_iomux & IOMUX_SEL_SDMMC_MASK)
 			rk_clrsetreg(&grf->gpio0d_iomux,
 				     GPIO0D6_SEL_MASK,
-				     GPIO0D6_SDMMC0_PWRENM1
-				     << GPIO0D6_SEL_SHIFT);
+				     GPIO0D6_GPIO << GPIO0D6_SEL_SHIFT);
 		else
 			rk_clrsetreg(&grf->gpio2a_iomux,
 				     GPIO2A7_SEL_MASK,
-				     GPIO2A7_SDMMC0_PWRENM0
-				     << GPIO2A7_SEL_SHIFT);
+				     GPIO2A7_GPIO << GPIO2A7_SEL_SHIFT);
 		rk_clrsetreg(&grf->gpio1a_iomux,
 			     GPIO1A0_SEL_MASK,
 			     GPIO1A0_CARD_DATA_CLK_CMD_DETN