5 Commits (938176a48274361c0b86b237ff6c0953a08233b3)

Author	SHA1	Message	Date
Wu, Josh	3a49cd7e1a	ARM: at91sam9x5: enable MCI0 support for 9x5ek board. ... Signed-off-by: Josh Wu <josh.wu@atmel.com> Signed-off-by: Andreas Bießmann <andreas.devel@googlemail.com>	12 years ago
Wu, Josh	1c5794a13e	at91sam9x5: set default EBI I/O drive configuration. ... This patch configure at91sam9x5's EBI drive I/O. Without this, When SD card boot, the nand flash read/write are not stable. Which will cause kernel MTD test fail (Since mainline kernel doesn't configure the EBI register). Signed-off-by: Josh Wu <josh.wu@atmel.com> Signed-off-by: Andreas Bießmann <andreas.devel@googlemail.com>	12 years ago
Wu, Josh	2ab4c74604	at91: 9x5: change SMC config timing that both works for PMECC & non-PMECC. ... Signed-off-by: Josh Wu <josh.wu@atmel.com> Tested-by: voice.shen@atmel.com Signed-off-by: Andreas Bießmann <andreas.devel@googlemail.com>	12 years ago
Bo Shen	4ed9c88603	arm : at91sam9x5 : fix a small bug for NAND ... fix a bug: when not boot from NAND, the NAND flash can not be detected. Using this to fix it Signed-off-by: Bo Shen <voice.shen@atmel.com> Signed-off-by: Andreas Bießmann <andreas.devel@googlemail.com>	12 years ago
Bo Shen	f7fa2f3740	arm : Atmel : add at91sam9x5ek board support ... Add at91sam9x5ek board support, this board support the following SoCs AT91SAM9G15, AT91SAM9G25, AT91SAM9G35, AT91SAM9X25, AT91SAM9X35 Using at91sam9x5ek_nandflash to configure for the board Now only supports NAND with software ECC boot up Signed-off-by: Bo Shen <voice.shen@atmel.com> [move MAINTAINERS entry to right place] Signed-off-by: Andreas Bießmann <andreas.devel@googlemail.com>	12 years ago