upstream u-boot with additional patches for our devices/boards: https://lists.denx.de/pipermail/u-boot/2017-March/282789.html (AXP crashes) ; Gbit ethernet patch for some LIME2 revisions ; with SPI flash support
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
 
 
 
 
 
 
u-boot/drivers/mmc/s5p_sdhci.c

296 lines
6.6 KiB

// SPDX-License-Identifier: GPL-2.0+
/*
* (C) Copyright 2012 SAMSUNG Electronics
* Jaehoon Chung <jh80.chung@samsung.com>
*/
#include <common.h>
#include <dm.h>
#include <malloc.h>
#include <sdhci.h>
#include <fdtdec.h>
#include <linux/libfdt.h>
#include <asm/gpio.h>
#include <asm/arch/mmc.h>
#include <asm/arch/clk.h>
#include <errno.h>
#include <asm/arch/pinmux.h>
#ifdef CONFIG_DM_MMC
struct s5p_sdhci_plat {
struct mmc_config cfg;
struct mmc mmc;
};
DECLARE_GLOBAL_DATA_PTR;
#endif
static char *S5P_NAME = "SAMSUNG SDHCI";
static void s5p_sdhci_set_control_reg(struct sdhci_host *host)
{
unsigned long val, ctrl;
/*
* SELCLKPADDS[17:16]
* 00 = 2mA
* 01 = 4mA
* 10 = 7mA
* 11 = 9mA
*/
sdhci_writel(host, SDHCI_CTRL4_DRIVE_MASK(0x3), SDHCI_CONTROL4);
val = sdhci_readl(host, SDHCI_CONTROL2);
val &= SDHCI_CTRL2_SELBASECLK_MASK(3);
val |= SDHCI_CTRL2_ENSTAASYNCCLR |
SDHCI_CTRL2_ENCMDCNFMSK |
SDHCI_CTRL2_ENFBCLKRX |
SDHCI_CTRL2_ENCLKOUTHOLD;
sdhci_writel(host, val, SDHCI_CONTROL2);
/*
* FCSEL3[31] FCSEL2[23] FCSEL1[15] FCSEL0[7]
* FCSel[1:0] : Rx Feedback Clock Delay Control
* Inverter delay means10ns delay if SDCLK 50MHz setting
* 01 = Delay1 (basic delay)
* 11 = Delay2 (basic delay + 2ns)
* 00 = Delay3 (inverter delay)
* 10 = Delay4 (inverter delay + 2ns)
*/
val = SDHCI_CTRL3_FCSEL0 | SDHCI_CTRL3_FCSEL1;
sdhci_writel(host, val, SDHCI_CONTROL3);
/*
* SELBASECLK[5:4]
* 00/01 = HCLK
* 10 = EPLL
* 11 = XTI or XEXTCLK
*/
ctrl = sdhci_readl(host, SDHCI_CONTROL2);
ctrl &= ~SDHCI_CTRL2_SELBASECLK_MASK(0x3);
ctrl |= SDHCI_CTRL2_SELBASECLK_MASK(0x2);
sdhci_writel(host, ctrl, SDHCI_CONTROL2);
}
static void s5p_set_clock(struct sdhci_host *host, u32 div)
{
/* ToDo : Use the Clock Framework */
set_mmc_clk(host->index, div);
}
static const struct sdhci_ops s5p_sdhci_ops = {
.set_clock = &s5p_set_clock,
.set_control_reg = &s5p_sdhci_set_control_reg,
};
static int s5p_sdhci_core_init(struct sdhci_host *host)
{
host->name = S5P_NAME;
host->quirks = SDHCI_QUIRK_NO_HISPD_BIT | SDHCI_QUIRK_BROKEN_VOLTAGE |
SDHCI_QUIRK_32BIT_DMA_ADDR |
SDHCI_QUIRK_WAIT_SEND_CMD | SDHCI_QUIRK_USE_WIDE8;
host->max_clk = 52000000;
host->voltages = MMC_VDD_32_33 | MMC_VDD_33_34 | MMC_VDD_165_195;
host->ops = &s5p_sdhci_ops;
if (host->bus_width == 8)
host->host_caps |= MMC_MODE_8BIT;
#ifndef CONFIG_BLK
return add_sdhci(host, 0, 400000);
#else
return 0;
#endif
}
int s5p_sdhci_init(u32 regbase, int index, int bus_width)
{
struct sdhci_host *host = calloc(1, sizeof(struct sdhci_host));
if (!host) {
printf("sdhci__host allocation fail!\n");
return -ENOMEM;
}
host->ioaddr = (void *)regbase;
host->index = index;
host->bus_width = bus_width;
return s5p_sdhci_core_init(host);
}
#if CONFIG_IS_ENABLED(OF_CONTROL)
struct sdhci_host sdhci_host[SDHCI_MAX_HOSTS];
static int do_sdhci_init(struct sdhci_host *host)
{
int dev_id, flag, ret;
flag = host->bus_width == 8 ? PINMUX_FLAG_8BIT_MODE : PINMUX_FLAG_NONE;
dev_id = host->index + PERIPH_ID_SDMMC0;
ret = exynos_pinmux_config(dev_id, flag);
if (ret) {
printf("external SD not configured\n");
return ret;
}
if (dm_gpio_is_valid(&host->pwr_gpio)) {
dm_gpio_set_value(&host->pwr_gpio, 1);
ret = exynos_pinmux_config(dev_id, flag);
if (ret) {
debug("MMC not configured\n");
return ret;
}
}
if (dm_gpio_is_valid(&host->cd_gpio)) {
ret = dm_gpio_get_value(&host->cd_gpio);
if (ret) {
debug("no SD card detected (%d)\n", ret);
return -ENODEV;
}
}
return s5p_sdhci_core_init(host);
}
static int sdhci_get_config(const void *blob, int node, struct sdhci_host *host)
{
int bus_width, dev_id;
unsigned int base;
/* Get device id */
dev_id = pinmux_decode_periph_id(blob, node);
if (dev_id < PERIPH_ID_SDMMC0 || dev_id > PERIPH_ID_SDMMC3) {
debug("MMC: Can't get device id\n");
return -EINVAL;
}
host->index = dev_id - PERIPH_ID_SDMMC0;
/* Get bus width */
bus_width = fdtdec_get_int(blob, node, "samsung,bus-width", 0);
if (bus_width <= 0) {
debug("MMC: Can't get bus-width\n");
return -EINVAL;
}
host->bus_width = bus_width;
/* Get the base address from the device node */
base = fdtdec_get_addr(blob, node, "reg");
if (!base) {
debug("MMC: Can't get base address\n");
return -EINVAL;
}
host->ioaddr = (void *)base;
gpio_request_by_name_nodev(offset_to_ofnode(node), "pwr-gpios", 0,
&host->pwr_gpio, GPIOD_IS_OUT);
gpio_request_by_name_nodev(offset_to_ofnode(node), "cd-gpios", 0,
&host->cd_gpio, GPIOD_IS_IN);
return 0;
}
static int process_nodes(const void *blob, int node_list[], int count)
{
struct sdhci_host *host;
int i, node, ret;
int failed = 0;
debug("%s: count = %d\n", __func__, count);
/* build sdhci_host[] for each controller */
for (i = 0; i < count; i++) {
node = node_list[i];
if (node <= 0)
continue;
host = &sdhci_host[i];
ret = sdhci_get_config(blob, node, host);
if (ret) {
printf("%s: failed to decode dev %d (%d)\n", __func__, i, ret);
failed++;
continue;
}
ret = do_sdhci_init(host);
if (ret && ret != -ENODEV) {
printf("%s: failed to initialize dev %d (%d)\n", __func__, i, ret);
failed++;
}
}
/* we only consider it an error when all nodes fail */
return (failed == count ? -1 : 0);
}
int exynos_mmc_init(const void *blob)
{
int count;
int node_list[SDHCI_MAX_HOSTS];
count = fdtdec_find_aliases_for_id(blob, "mmc",
COMPAT_SAMSUNG_EXYNOS_MMC, node_list,
SDHCI_MAX_HOSTS);
return process_nodes(blob, node_list, count);
}
#endif
#ifdef CONFIG_DM_MMC
static int s5p_sdhci_probe(struct udevice *dev)
{
struct s5p_sdhci_plat *plat = dev_get_platdata(dev);
struct mmc_uclass_priv *upriv = dev_get_uclass_priv(dev);
struct sdhci_host *host = dev_get_priv(dev);
int ret;
ret = sdhci_get_config(gd->fdt_blob, dev_of_offset(dev), host);
if (ret)
return ret;
ret = do_sdhci_init(host);
if (ret)
return ret;
ret = sdhci_setup_cfg(&plat->cfg, host, 0, 400000);
if (ret)
return ret;
host->mmc = &plat->mmc;
host->mmc->priv = host;
host->mmc->dev = dev;
upriv->mmc = host->mmc;
return sdhci_probe(dev);
}
static int s5p_sdhci_bind(struct udevice *dev)
{
struct s5p_sdhci_plat *plat = dev_get_platdata(dev);
int ret;
ret = sdhci_bind(dev, &plat->mmc, &plat->cfg);
if (ret)
return ret;
return 0;
}
static const struct udevice_id s5p_sdhci_ids[] = {
{ .compatible = "samsung,exynos4412-sdhci"},
{ }
};
U_BOOT_DRIVER(s5p_sdhci_drv) = {
.name = "s5p_sdhci",
.id = UCLASS_MMC,
.of_match = s5p_sdhci_ids,
.bind = s5p_sdhci_bind,
.ops = &sdhci_ops,
.probe = s5p_sdhci_probe,
.priv_auto_alloc_size = sizeof(struct sdhci_host),
.platdata_auto_alloc_size = sizeof(struct s5p_sdhci_plat),
};
#endif /* CONFIG_DM_MMC */