upstream u-boot with additional patches for our devices/boards:
https://lists.denx.de/pipermail/u-boot/2017-March/282789.html (AXP crashes) ;
Gbit ethernet patch for some LIME2 revisions ;
with SPI flash support
You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
125 lines
3.0 KiB
125 lines
3.0 KiB
/*
|
|
* Copyright (C) 2010 Atmel Corporation
|
|
*
|
|
* Copyright (C) 2012 Andreas Bießmann <andreas.devel@googlemail.com>
|
|
*
|
|
* SPDX-License-Identifier: GPL-2.0+
|
|
*/
|
|
#include <common.h>
|
|
|
|
#include <spi.h>
|
|
#include <netdev.h>
|
|
|
|
#include <asm/io.h>
|
|
#include <asm/sdram.h>
|
|
#include <asm/arch/clk.h>
|
|
#include <asm/arch/gpio.h>
|
|
#include <asm/arch/hmatrix.h>
|
|
#include <asm/arch/mmu.h>
|
|
#include <asm/arch/portmux.h>
|
|
|
|
DECLARE_GLOBAL_DATA_PTR;
|
|
|
|
struct mmu_vm_range mmu_vmr_table[CONFIG_SYS_NR_VM_REGIONS] = {
|
|
{
|
|
/* Atmel AT49BV640D 8 MiB x16 NOR flash on NCS0 */
|
|
.virt_pgno = CONFIG_SYS_FLASH_BASE >> MMU_PAGE_SHIFT,
|
|
.nr_pages = CONFIG_SYS_FLASH_SIZE >> MMU_PAGE_SHIFT,
|
|
.phys = (CONFIG_SYS_FLASH_BASE >> MMU_PAGE_SHIFT)
|
|
| MMU_VMR_CACHE_NONE,
|
|
}, {
|
|
/* Micron MT29F2G16AAD 256 MiB x16 NAND flash on NCS3 */
|
|
.virt_pgno = EBI_SRAM_CS3_BASE >> MMU_PAGE_SHIFT,
|
|
.nr_pages = EBI_SRAM_CS3_SIZE >> MMU_PAGE_SHIFT,
|
|
.phys = (EBI_SRAM_CS3_BASE >> MMU_PAGE_SHIFT)
|
|
| MMU_VMR_CACHE_NONE,
|
|
}, {
|
|
/* 2x16-bit ISSI IS42S16320B 64 MiB SDRAM (128 MiB total) */
|
|
.virt_pgno = CONFIG_SYS_SDRAM_BASE >> MMU_PAGE_SHIFT,
|
|
.nr_pages = EBI_SDRAM_SIZE >> MMU_PAGE_SHIFT,
|
|
.phys = (CONFIG_SYS_SDRAM_BASE >> MMU_PAGE_SHIFT)
|
|
| MMU_VMR_CACHE_WRBACK,
|
|
},
|
|
};
|
|
|
|
static const struct sdram_config sdram_config = {
|
|
.data_bits = SDRAM_DATA_32BIT,
|
|
.row_bits = 13,
|
|
.col_bits = 10,
|
|
.bank_bits = 2,
|
|
.cas = 3,
|
|
.twr = 2,
|
|
.trc = 7,
|
|
.trp = 2,
|
|
.trcd = 2,
|
|
.tras = 5,
|
|
.txsr = 6,
|
|
/* 7.81 us */
|
|
.refresh_period = (781 * (SDRAMC_BUS_HZ / 1000)) / 100000,
|
|
};
|
|
|
|
int board_early_init_f(void)
|
|
{
|
|
/* Enable SDRAM in the EBI mux */
|
|
hmatrix_slave_write(EBI, SFR, HMATRIX_BIT(EBI_SDRAM_ENABLE)
|
|
| HMATRIX_BIT(EBI_NAND_ENABLE));
|
|
|
|
portmux_enable_ebi(32, 23, PORTMUX_EBI_NAND,
|
|
PORTMUX_DRIVE_HIGH);
|
|
portmux_select_gpio(PORTMUX_PORT_E, 1 << 23,
|
|
PORTMUX_DIR_OUTPUT | PORTMUX_INIT_HIGH
|
|
| PORTMUX_DRIVE_MIN);
|
|
|
|
sdram_init(uncached(EBI_SDRAM_BASE), &sdram_config);
|
|
|
|
portmux_enable_usart1(PORTMUX_DRIVE_MIN);
|
|
|
|
#if defined(CONFIG_MACB)
|
|
portmux_enable_macb0(PORTMUX_MACB_MII, PORTMUX_DRIVE_HIGH);
|
|
portmux_enable_macb1(PORTMUX_MACB_MII, PORTMUX_DRIVE_HIGH);
|
|
#endif
|
|
#if defined(CONFIG_MMC)
|
|
portmux_enable_mmci(0, PORTMUX_MMCI_4BIT, PORTMUX_DRIVE_LOW);
|
|
#endif
|
|
#if defined(CONFIG_ATMEL_SPI)
|
|
portmux_enable_spi0(1 << 0, PORTMUX_DRIVE_LOW);
|
|
#endif
|
|
|
|
return 0;
|
|
}
|
|
|
|
int board_early_init_r(void)
|
|
{
|
|
gd->bd->bi_phy_id[0] = 0x01;
|
|
gd->bd->bi_phy_id[1] = 0x03;
|
|
return 0;
|
|
}
|
|
|
|
#ifdef CONFIG_CMD_NET
|
|
int board_eth_init(bd_t *bi)
|
|
{
|
|
macb_eth_initialize(0, (void *)ATMEL_BASE_MACB0, bi->bi_phy_id[0]);
|
|
macb_eth_initialize(1, (void *)ATMEL_BASE_MACB1, bi->bi_phy_id[1]);
|
|
return 0;
|
|
}
|
|
#endif
|
|
|
|
/* SPI chip select control */
|
|
#ifdef CONFIG_ATMEL_SPI
|
|
#define ATNGW100_DATAFLASH_CS_PIN GPIO_PIN_PA(3)
|
|
|
|
int spi_cs_is_valid(unsigned int bus, unsigned int cs)
|
|
{
|
|
return bus == 0 && cs == 0;
|
|
}
|
|
|
|
void spi_cs_activate(struct spi_slave *slave)
|
|
{
|
|
gpio_set_value(ATNGW100_DATAFLASH_CS_PIN, 0);
|
|
}
|
|
|
|
void spi_cs_deactivate(struct spi_slave *slave)
|
|
{
|
|
gpio_set_value(ATNGW100_DATAFLASH_CS_PIN, 1);
|
|
}
|
|
#endif /* CONFIG_ATMEL_SPI */
|
|
|