armv8: ls1088aqds: Change phy mode to PHY_INTERFACE_MODE_RGMII_ID

Since TX delay is now enabled only in PHY_INTERFACE_MODE_RGMII_ID
PHY_INTERFACE_MODE_RGMII_TXID.

These change where introduced in phy driver in commit 05b29aa0cb
("net: phy: realtek: fix enabling of the TX-delay for RTL8211F").

Signed-off-by: Ashish Kumar <Ashish.Kumar@nxp.com>
Reviewed-by: York Sun <york.sun@nxp.com>

board/freescale/ls1088a/eth_ls1088aqds.c

@@ -634,6 +634,7 @@ int board_eth_init(bd_t *bis)
 	for (i = WRIOP1_DPMAC1; i < NUM_WRIOP_PORTS; i++) {
 		switch (wriop_get_enet_if(i)) {
 		case PHY_INTERFACE_MODE_RGMII:
+		case PHY_INTERFACE_MODE_RGMII_ID:
 			ls1088a_handle_phy_interface_rgmii(i);
 			break;
 		case PHY_INTERFACE_MODE_QSGMII:

drivers/net/ldpaa_eth/ls1088a.c

@@ -99,7 +99,7 @@ void fsl_rgmii_init(void)
 	ec >>= FSL_CHASSIS3_RCWSR25_EC1_PRTCL_SHIFT;
 
 	if (!ec)
-		wriop_init_dpmac_enet_if(4, PHY_INTERFACE_MODE_RGMII);
+		wriop_init_dpmac_enet_if(4, PHY_INTERFACE_MODE_RGMII_ID);
 #endif
 
 #ifdef CONFIG_SYS_FSL_EC2
@@ -108,7 +108,7 @@ void fsl_rgmii_init(void)
 	ec >>= FSL_CHASSIS3_RCWSR25_EC2_PRTCL_SHIFT;
 
 	if (!ec)
-		wriop_init_dpmac_enet_if(5, PHY_INTERFACE_MODE_RGMII);
+		wriop_init_dpmac_enet_if(5, PHY_INTERFACE_MODE_RGMII_ID);
 #endif
 }
 #endif