pcnet: enable the NOUFLO feature

On relatively slow boards (such as the MIPS Malta with an FPGA core
card) it can be extremely common for transmits to underflow - to the
point where it appears they simply do not work at all. Setting the
NOUFLO bit causes the ethernet controller to not begin transmission on
the wire until a transmit start point is reached. Setting that transmit
start point to the full packet will cause the controller to only
transmit the packet once it has buffered it entirely thus preventing any
transmit underflows from occuring and allowing the controller to
function on slower boards.

Signed-off-by: Paul Burton <paul.burton@imgtec.com>

drivers/net/pcnet.c

@@ -312,6 +312,21 @@ static int pcnet_init(struct eth_device *dev, bd_t *bis)
 	pcnet_write_bcr(dev, 32, val);
 
 	/*
+	 * Enable NOUFLO on supported controllers, with the transmit
+	 * start point set to the full packet. This will cause entire
+	 * packets to be buffered by the ethernet controller before
+	 * transmission, eliminating underflows which are common on
+	 * slower devices. Controllers which do not support NOUFLO will
+	 * simply be left with a larger transmit FIFO threshold.
+	 */
+	val = pcnet_read_bcr(dev, 18);
+	val |= 1 << 11;
+	pcnet_write_bcr(dev, 18, val);
+	val = pcnet_read_csr(dev, 80);
+	val |= 0x3 << 10;
+	pcnet_write_csr(dev, 80, val);
+
+	/*
 	 * We only maintain one structure because the drivers will never
 	 * be used concurrently. In 32bit mode the RX and TX ring entries
 	 * must be aligned on 16-byte boundaries.