i2c: omap: Modify code to work without CONFIG_I2C_HARD

Drop use of this long-deprecated option.

Signed-off-by: Simon Glass <sjg@chromium.org>
Suggested-by: Lokesh Vutla <lokeshvutla@ti.com>
Reviewed-by: Tom Rini <trini@konsulko.com>

board/ti/am335x/board.c

@@ -72,7 +72,8 @@ void do_board_detect(void)
 	enable_i2c0_pin_mux();
 	i2c_init(CONFIG_SYS_OMAP24_I2C_SPEED, CONFIG_SYS_OMAP24_I2C_SLAVE);
 
-	if (ti_i2c_eeprom_am_get(-1, CONFIG_SYS_I2C_EEPROM_ADDR))
+	if (ti_i2c_eeprom_am_get(CONFIG_EEPROM_BUS_ADDRESS,
+				 CONFIG_EEPROM_CHIP_ADDRESS))
 		printf("ti_i2c_eeprom_init failed\n");
 }
 #endif

board/ti/am43xx/board.c

@@ -42,7 +42,8 @@ static struct ctrl_dev *cdev = (struct ctrl_dev *)CTRL_DEVICE_BASE;
 #ifdef CONFIG_TI_I2C_BOARD_DETECT
 void do_board_detect(void)
 {
-	if (ti_i2c_eeprom_am_get(-1, CONFIG_SYS_I2C_EEPROM_ADDR))
+	if (ti_i2c_eeprom_am_get(CONFIG_EEPROM_BUS_ADDRESS,
+				 CONFIG_EEPROM_CHIP_ADDRESS))
 		printf("ti_i2c_eeprom_init failed\n");
 }
 #endif