diff --git a/arch/arm/cpu/armv7/uniphier/Kconfig b/arch/arm/cpu/armv7/uniphier/Kconfig
index 0556e4b..5c5a84f 100644
--- a/arch/arm/cpu/armv7/uniphier/Kconfig
+++ b/arch/arm/cpu/armv7/uniphier/Kconfig
@@ -50,21 +50,12 @@ endchoice
 
 config CMD_PINMON
 	bool "Enable boot mode pins monitor command"
-	depends on !SPL_BUILD
 	default y
 	help
 	  The command "pinmon" shows the state of the boot mode pins.
 	  The boot mode pins are latched when the system reset is deasserted
 	  and determine which device the system should load a boot image from.
 
-config SOC_INIT
-	bool
-	default SPL_BUILD
-
-config DRAM_INIT
-	bool
-	default SPL_BUILD
-
 config CMD_DDRPHY_DUMP
 	bool "Enable dump command of DDR PHY parameters"
 	depends on !SPL_BUILD
@@ -74,7 +65,7 @@ config CMD_DDRPHY_DUMP
 
 choice
 	prompt "DDR3 Frequency select"
-	depends on DRAM_INIT
+	depends on SPL_BUILD
 
 config DDR_FREQ_1600
 	bool "DDR3 1600"
diff --git a/arch/arm/cpu/armv7/uniphier/Makefile b/arch/arm/cpu/armv7/uniphier/Makefile
index 713a0d7..df418dd 100644
--- a/arch/arm/cpu/armv7/uniphier/Makefile
+++ b/arch/arm/cpu/armv7/uniphier/Makefile
@@ -2,24 +2,32 @@
 # SPDX-License-Identifier:	GPL-2.0+
 #
 
-obj-$(CONFIG_SPL_BUILD) += lowlevel_init.o init_page_table.o
-obj-$(CONFIG_SPL_BUILD) += spl.o
+ifdef CONFIG_SPL_BUILD
+
+obj-y += lowlevel_init.o
+obj-y += init_page_table.o
+obj-y += spl.o
+obj-y += ddrphy_training.o
+
+else
 
-obj-y += timer.o
-obj-y += reset.o
-obj-y += cache_uniphier.o
-obj-y += dram_init.o
-obj-$(CONFIG_DRAM_INIT) += ddrphy_training.o
 obj-$(CONFIG_BOARD_EARLY_INIT_F) += board_early_init_f.o
 obj-$(CONFIG_DISPLAY_CPUINFO) += cpu_info.o
 obj-$(CONFIG_MISC_INIT_F) += print_misc_info.o
+obj-y += dram_init.o
+obj-y += board_common.o
 obj-$(CONFIG_BOARD_EARLY_INIT_R) += board_early_init_r.o
 obj-$(CONFIG_BOARD_LATE_INIT) += board_late_init.o
+obj-y += reset.o
+obj-y += cache_uniphier.o
 obj-$(CONFIG_UNIPHIER_SMP) += smp.o
 obj-$(CONFIG_CMD_PINMON) += cmd_pinmon.o
 obj-$(CONFIG_CMD_DDRPHY_DUMP) += cmd_ddrphy.o
 
-obj-y += board_common.o
+endif
+
+obj-y += timer.o
+
 obj-$(CONFIG_PFC_MICRO_SUPPORT_CARD) += support_card.o
 obj-$(CONFIG_DCC_MICRO_SUPPORT_CARD) += support_card.o
 
diff --git a/arch/arm/cpu/armv7/uniphier/ph1-ld4/Makefile b/arch/arm/cpu/armv7/uniphier/ph1-ld4/Makefile
index bef1b8a..72f4663 100644
--- a/arch/arm/cpu/armv7/uniphier/ph1-ld4/Makefile
+++ b/arch/arm/cpu/armv7/uniphier/ph1-ld4/Makefile
@@ -2,10 +2,13 @@
 # SPDX-License-Identifier:	GPL-2.0+
 #
 
-obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o
-obj-y += boot-mode.o
+ifdef CONFIG_SPL_BUILD
 obj-$(CONFIG_DEBUG_LL) += lowlevel_debug.o
-obj-$(CONFIG_SOC_INIT) += bcu_init.o sbc_init.o sg_init.o pll_init.o \
-								clkrst_init.o
+obj-y += bcu_init.o sbc_init.o sg_init.o pll_init.o clkrst_init.o \
+	pll_spectrum.o umc_init.o ddrphy_init.o
+else
 obj-$(CONFIG_BOARD_EARLY_INIT_F) += pinctrl.o
-obj-$(CONFIG_DRAM_INIT) += pll_spectrum.o umc_init.o ddrphy_init.o
+obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o
+endif
+
+obj-y += boot-mode.o
diff --git a/arch/arm/cpu/armv7/uniphier/ph1-pro4/Makefile b/arch/arm/cpu/armv7/uniphier/ph1-pro4/Makefile
index 484e978..e330fda 100644
--- a/arch/arm/cpu/armv7/uniphier/ph1-pro4/Makefile
+++ b/arch/arm/cpu/armv7/uniphier/ph1-pro4/Makefile
@@ -2,9 +2,13 @@
 # SPDX-License-Identifier:	GPL-2.0+
 #
 
-obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o
-obj-y += boot-mode.o
+ifdef CONFIG_SPL_BUILD
 obj-$(CONFIG_DEBUG_LL) += lowlevel_debug.o
-obj-$(CONFIG_SOC_INIT) += sbc_init.o sg_init.o pll_init.o clkrst_init.o
+obj-y += sbc_init.o sg_init.o pll_init.o clkrst_init.o \
+	pll_spectrum.o umc_init.o ddrphy_init.o
+else
 obj-$(CONFIG_BOARD_EARLY_INIT_F) += pinctrl.o
-obj-$(CONFIG_DRAM_INIT) += pll_spectrum.o umc_init.o ddrphy_init.o
+obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o
+endif
+
+obj-y += boot-mode.o
diff --git a/arch/arm/cpu/armv7/uniphier/ph1-sld8/Makefile b/arch/arm/cpu/armv7/uniphier/ph1-sld8/Makefile
index bef1b8a..72f4663 100644
--- a/arch/arm/cpu/armv7/uniphier/ph1-sld8/Makefile
+++ b/arch/arm/cpu/armv7/uniphier/ph1-sld8/Makefile
@@ -2,10 +2,13 @@
 # SPDX-License-Identifier:	GPL-2.0+
 #
 
-obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o
-obj-y += boot-mode.o
+ifdef CONFIG_SPL_BUILD
 obj-$(CONFIG_DEBUG_LL) += lowlevel_debug.o
-obj-$(CONFIG_SOC_INIT) += bcu_init.o sbc_init.o sg_init.o pll_init.o \
-								clkrst_init.o
+obj-y += bcu_init.o sbc_init.o sg_init.o pll_init.o clkrst_init.o \
+	pll_spectrum.o umc_init.o ddrphy_init.o
+else
 obj-$(CONFIG_BOARD_EARLY_INIT_F) += pinctrl.o
-obj-$(CONFIG_DRAM_INIT) += pll_spectrum.o umc_init.o ddrphy_init.o
+obj-$(if $(CONFIG_OF_CONTROL),,y) += platdevice.o
+endif
+
+obj-y += boot-mode.o