PPC4xx (Sequoia): Fix Ethernet "remote fault" problems

Every now and then a Sequoia board (or equivalent hardware) had
problems connecting to a Gigabit capable network interface.

There were differences in the PHY setup between Linux and U-Boot.

This patch fixes the problem. Apparently "remote fault" is being set,
which signals to some devices (on the other end of the cable) that a
fault has occurred, while other devices ignore it. I believe the RF bit
was causing the issue, but I removed T4 also, to match up with Linux.

Signed-off-by: Mike Nuss <mike@terascala.com>

cpu/ppc4xx/miiphy.c

@@ -143,9 +143,8 @@ int phy_setup_aneg (char *devname, unsigned char addr)
 	u16 adv;
 
 	miiphy_read (devname, addr, PHY_ANAR, &adv);
-	adv |= (PHY_ANLPAR_ACK | PHY_ANLPAR_RF | PHY_ANLPAR_T4 |
-		PHY_ANLPAR_TXFD | PHY_ANLPAR_TX | PHY_ANLPAR_10FD |
-		PHY_ANLPAR_10);
+	adv |= (PHY_ANLPAR_ACK  | PHY_ANLPAR_TXFD | PHY_ANLPAR_TX |
+		PHY_ANLPAR_10FD | PHY_ANLPAR_10);
 	miiphy_write (devname, addr, PHY_ANAR, adv);
 
 	miiphy_read (devname, addr, PHY_1000BTCR, &adv);