spl: use TPL_SYS_MALLOC_F_LEN for TPL

The (upstream) changes to break up SYS_MALLOC_F_LEN for the full
U-Boot and the SPL stage, break TPL (if simple malloc is enabled in
TPL).

This adds support for a TPL-variant of SYS_MALLOC_F_LEN:
- adds TPL_SYS_MALLOC_F_LEN
- rewrites a test for CONFIG_SPL_SYS_MALLOC_F_LEN to access
  CONFIG_VAL(SYS_MALLOC_F_LEN)

Signed-off-by: Philipp Tomsich <philipp.tomsich@theobroma-systems.com>
Reviewed-by: Simon Glass <sjg@chromium.org>

Kconfig

@@ -96,7 +96,17 @@ config SYS_MALLOC_F_LEN
 	  initial serial device and any others that are needed.
 
 config SPL_SYS_MALLOC_F_LEN
-        hex "Size of malloc() pool in spl before relocation"
+        hex "Size of malloc() pool in SPL before relocation"
+        depends on SYS_MALLOC_F
+        default SYS_MALLOC_F_LEN
+        help
+          Before relocation, memory is very limited on many platforms. Still,
+          we can provide a small malloc() pool if needed. Driver model in
+          particular needs this to operate, so that it can allocate the
+          initial serial device and any others that are needed.
+
+config TPL_SYS_MALLOC_F_LEN
+        hex "Size of malloc() pool in TPL before relocation"
         depends on SYS_MALLOC_F
         default SYS_MALLOC_F_LEN
         help

common/spl/spl.c

@@ -486,7 +486,7 @@ ulong spl_relocate_stack_gd(void)
 	gd_t *new_gd;
 	ulong ptr = CONFIG_SPL_STACK_R_ADDR;
 
-#if defined(CONFIG_SPL_SYS_MALLOC_SIMPLE) && CONFIG_SPL_SYS_MALLOC_F_LEN
+#if defined(CONFIG_SPL_SYS_MALLOC_SIMPLE) && CONFIG_VAL(SYS_MALLOC_F_LEN)
 	if (CONFIG_SPL_STACK_R_MALLOC_SIMPLE_LEN) {
 		ptr -= CONFIG_SPL_STACK_R_MALLOC_SIMPLE_LEN;
 		gd->malloc_base = ptr;