socrates: changes to support FDT

Signed-off-by: Sergei Poselenov <sposelenov@emcraft.com>
Signed-off-by: Wolfgang Denk <wd@denx.de>
master
Sergei Poselenov 17 years ago committed by Wolfgang Denk
parent 5d108ac8f4
commit e18575d5f5
  1. 25
      board/socrates/socrates.c
  2. 58
      include/configs/socrates.h

@ -33,6 +33,8 @@
#include <asm/immap_85xx.h>
#include <ioports.h>
#include <flash.h>
#include <libfdt.h>
#include <fdt_support.h>
DECLARE_GLOBAL_DATA_PTR;
@ -184,3 +186,26 @@ int board_early_init_r (void)
return (0);
}
#endif /* CONFIG_BOARD_EARLY_INIT_R */
#if defined(CONFIG_OF_LIBFDT) && defined(CONFIG_OF_BOARD_SETUP)
void
ft_board_setup(void *blob, bd_t *bd)
{
u32 val[4];
int rc;
ft_cpu_setup(blob, bd);
/* Fixup NOR mapping */
val[0] = 0; /* chip select number */
val[1] = 0; /* always 0 */
val[2] = gd->bd->bi_flashstart;
val[3] = gd->bd->bi_flashsize;
rc = fdt_find_and_setprop(blob, "/localbus", "ranges",
val, sizeof(val), 1);
if (rc)
printf("Unable to update property NOR mapping, err=%s\n",
fdt_strerror(rc));
}
#endif /* defined(CONFIG_OF_LIBFDT) && defined(CONFIG_OF_BOARD_SETUP) */

@ -114,11 +114,9 @@
#define CFG_DDR_CLK_CONTROL 0x03800000
#define CFG_SDRAM_SIZE 256 /* in Megs */
#if 1
#define CONFIG_SPD_EEPROM 1 /* Use SPD EEPROM for DDR setup*/
#define SPD_EEPROM_ADDRESS 0x50 /* DDR DIMM */
#define MPC85xx_DDR_SDRAM_CLK_CNTL /* 85xx has clock control reg */
#endif
/*
* Flash on the Local Bus
@ -145,7 +143,7 @@
#define CFG_FLASH_EMPTY_INFO /* print 'E' for empty sector */
#define CFG_MAX_FLASH_BANKS 2 /* number of banks */
#define CFG_MAX_FLASH_SECT 512 /* sectors per device */
#define CFG_MAX_FLASH_SECT 256 /* sectors per device */
#undef CFG_FLASH_CHECKSUM
#define CFG_FLASH_ERASE_TOUT 60000 /* Flash Erase Timeout (ms) */
#define CFG_FLASH_WRITE_TOUT 500 /* Flash Write Timeout (ms) */
@ -205,28 +203,8 @@
#define CFG_I2C_OFFSET 0x3000
/* I2C RTC */
#define CONFIG_RTC_DS1337 /* Use ds1337 rtc via i2c */
#define CFG_I2C_RTC_ADDR 0x68 /* at address 0x68 */
#if 0
/* I2C EEPROM */
/*
* EEPROM configuration for onboard EEPROM M24C32 (M24C64 should work also).
*/
#define CFG_I2C_EEPROM_ADDR 0x50 /* 1010000x */
#define CFG_I2C_EEPROM_ADDR_LEN 2
#define CFG_EEPROM_PAGE_WRITE_BITS 5 /* =32 Bytes per write */
#define CFG_EEPROM_PAGE_WRITE_ENABLE
#define CFG_EEPROM_PAGE_WRITE_DELAY_MS 20
#define CFG_I2C_MULTI_EEPROMS 1 /* more than one eeprom */
/* I2C SYSMON (LM75) */
#define CONFIG_DTT_LM75 1 /* ON Semi's LM75 */
#define CONFIG_DTT_SENSORS {0} /* Sensor addresses */
#define CFG_DTT_MAX_TEMP 70
#define CFG_DTT_LOW_TEMP -30
#define CFG_DTT_HYSTERESIS 3
#endif
#define CONFIG_RTC_RX8025 /* Use Epson rx8025 rtc via i2c */
#define CFG_I2C_RTC_ADDR 0x32 /* at address 0x32 */
/* RapidIO MMU */
#define CFG_RIO_MEM_BASE 0xc0000000 /* base address */
@ -280,6 +258,9 @@
#define CONFIG_ETHPRIME "TSEC0"
#define CONFIG_PHY_GIGE 1 /* Include GbE speed/duplex detection */
#define CONFIG_HAS_ETH0
#define CONFIG_HAS_ETH1
/*
* Environment
*/
@ -379,7 +360,7 @@
#undef CONFIG_BOOTARGS /* the boot command will set bootargs */
#define CONFIG_EXTRA_ENV_SETTINGS \
"bootfile=/tftpboot/socrates\0" \
"bootfile=/tftpboot/socrates/uImage\0" \
"netdev=eth0\0" \
"consdev=ttyS0\0" \
"nfsargs=setenv bootargs root=/dev/nfs rw " \
@ -390,15 +371,22 @@
":$hostname:$netdev:off panic=1\0" \
"addcons=setenv bootargs $bootargs " \
"console=$consdev,$baudrate\0" \
"flash_nfs=run nfsargs addip addcons;" \
"bootm $kernel_addr\0" \
"flash_self=run ramargs addip addcons;" \
"bootm $kernel_addr $ramdisk_addr\0" \
"net_nfs=tftp $loadaddr $bootfile;" \
"run nfsargs addip addcons;bootm\0" \
"bootm ${kernel_addr} ${ramdisk_addr} ${fdt_addr}\0" \
"flash_nfs=run nfsargs addip addcons;" \
"bootm ${kernel_addr} - ${fdt_addr}\0" \
"net_nfs=tftp ${kernel_addr_r} ${bootfile}; " \
"tftp ${fdt_addr_r} ${fdt_file}; " \
"run nfsargs addip addcons;" \
"bootm ${kernel_addr_r} - ${fdt_addr_r}\0" \
"fdt_file=socrates/socrates.dtb\0" \
"fdt_addr_r=B00000\0" \
"fdt_addr=FC1E0000\0" \
"rootpath=/opt/eldk/ppc_85xx\0" \
"kernel_addr=FE000000\0" \
"ramdisk_addr=FE180000\0" \
"kernel_addr=FC000000\0" \
"kernel_addr_r=200000\0" \
"ramdisk_addr=FC200000\0" \
"ramdisk_addr_r=400000\0" \
"load=tftp 100000 /tftpboot/$hostname/u-boot.bin\0" \
"update=protect off fffc0000 ffffffff;era fffc0000 ffffffff;" \
"cp.b 100000 fffc0000 40000;" \
@ -407,4 +395,8 @@
""
#define CONFIG_BOOTCOMMAND "run flash_self"
/* pass open firmware flat tree */
#define CONFIG_OF_LIBFDT 1
#define CONFIG_OF_BOARD_SETUP 1
#endif /* __CONFIG_H */

Loading…
Cancel
Save