pico-imx6ul: Update the defconfig

The defconfig/config.h file were merged but were already out of sync
with mainline.  This brings them further into line now.

Cc: Richard Hu <richard.hu@technexion.com>
Cc: Fabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: Tom Rini <trini@konsulko.com>

configs/pico-imx6ul_defconfig

@@ -1,5 +1,22 @@
 CONFIG_ARM=y
 CONFIG_ARCH_MX6=y
-CONFIG_SYS_EXTRA_OPTIONS="IMX_CONFIG=board/technexion/pico-imx6ul/imximage.cfg"
 CONFIG_TARGET_PICO_IMX6UL=y
+CONFIG_SYS_EXTRA_OPTIONS="IMX_CONFIG=board/technexion/pico-imx6ul/imximage.cfg"
+CONFIG_CMD_BOOTZ=y
+# CONFIG_CMD_IMLS is not set
+CONFIG_CMD_MEMTEST=y
+# CONFIG_CMD_FLASH is not set
+CONFIG_CMD_MMC=y
+CONFIG_CMD_USB=y
+CONFIG_CMD_USB_MASS_STORAGE=y
+CONFIG_CMD_GPIO=y
+CONFIG_CMD_DHCP=y
+CONFIG_CMD_MII=y
+CONFIG_CMD_PING=y
+CONFIG_CMD_CACHE=y
+CONFIG_CMD_EXT2=y
+CONFIG_CMD_EXT4=y
+CONFIG_CMD_EXT4_WRITE=y
+CONFIG_CMD_FAT=y
+CONFIG_CMD_FS_GENERIC=y
 CONFIG_OF_LIBFDT=y

include/configs/pico-imx6ul.h

@@ -31,14 +31,11 @@
 #define CONFIG_SYS_FSL_ESDHC_ADDR	USDHC1_BASE_ADDR
 
 #define CONFIG_MMC
-#define CONFIG_CMD_MMC
 #define CONFIG_GENERIC_MMC
-#define CONFIG_CMD_FAT
 #define CONFIG_DOS_PARTITION
 #define CONFIG_SUPPORT_EMMC_BOOT
 
 /* USB Configs */
-#define CONFIG_CMD_USB
 #define CONFIG_USB_EHCI
 #define CONFIG_USB_EHCI_MX6
 #define CONFIG_USB_STORAGE
@@ -52,7 +49,6 @@
 #define CONFIG_USB_GADGET_DUALSPEED
 #define CONFIG_USB_GADGET
 
-#define CONFIG_CMD_USB_MASS_STORAGE
 #define CONFIG_USB_FUNCTION_MASS_STORAGE
 #define CONFIG_USB_GADGET_DOWNLOAD
 #define CONFIG_USB_GADGET_VBUS_DRAW	2
@@ -100,7 +96,6 @@
 		   "fi; " \
 	   "else run netboot; fi"
 
-#define CONFIG_CMD_MEMTEST
 #define CONFIG_SYS_MEMTEST_START	0x80000000
 #define CONFIG_SYS_MEMTEST_END		CONFIG_SYS_MEMTEST_START + SZ_128M
 
@@ -134,7 +129,4 @@
 #define CONFIG_SYS_MMC_ENV_PART		0
 #define CONFIG_MMCROOT			"/dev/mmcblk0p2"
 
-#define CONFIG_CMD_BOOTZ
-#define CONFIG_CMD_CACHE
-
 #endif /* __PICO_IMX6UL_CONFIG_H */