upstream u-boot with additional patches for our devices/boards: https://lists.denx.de/pipermail/u-boot/2017-March/282789.html (AXP crashes) ; Gbit ethernet patch for some LIME2 revisions ; with SPI flash support
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
 
 
 
 
 
 
u-boot/drivers/mtd/nand/pxa3xx_nand.h

64 lines
2.0 KiB

#ifndef __ASM_ARCH_PXA3XX_NAND_H
#define __ASM_ARCH_PXA3XX_NAND_H
#include <linux/mtd/mtd.h>
#include <linux/mtd/partitions.h>
struct pxa3xx_nand_timing {
unsigned int tCH; /* Enable signal hold time */
unsigned int tCS; /* Enable signal setup time */
unsigned int tWH; /* ND_nWE high duration */
unsigned int tWP; /* ND_nWE pulse time */
unsigned int tRH; /* ND_nRE high duration */
unsigned int tRP; /* ND_nRE pulse width */
unsigned int tR; /* ND_nWE high to ND_nRE low for read */
unsigned int tWHR; /* ND_nWE high to ND_nRE low for status read */
unsigned int tAR; /* ND_ALE low to ND_nRE low delay */
};
struct pxa3xx_nand_flash {
uint32_t chip_id;
unsigned int flash_width; /* Width of Flash memory (DWIDTH_M) */
unsigned int dfc_width; /* Width of flash controller(DWIDTH_C) */
struct pxa3xx_nand_timing *timing; /* NAND Flash timing */
};
/*
* Current pxa3xx_nand controller has two chip select which
* both be workable.
*
* Notice should be taken that:
* When you want to use this feature, you should not enable the
* keep configuration feature, for two chip select could be
* attached with different nand chip. The different page size
* and timing requirement make the keep configuration impossible.
*/
/* The max num of chip select current support */
#define NUM_CHIP_SELECT (2)
struct pxa3xx_nand_platform_data {
/* the data flash bus is shared between the Static Memory
* Controller and the Data Flash Controller, the arbiter
* controls the ownership of the bus
*/
int enable_arbiter;
/* allow platform code to keep OBM/bootloader defined NFC config */
int keep_config;
/* indicate how many chip selects will be used */
int num_cs;
/* use an flash-based bad block table */
bool flash_bbt;
/* requested ECC strength and ECC step size */
int ecc_strength, ecc_step_size;
const struct mtd_partition *parts[NUM_CHIP_SELECT];
unsigned int nr_parts[NUM_CHIP_SELECT];
const struct pxa3xx_nand_flash *flash;
size_t num_flash;
};
#endif /* __ASM_ARCH_PXA3XX_NAND_H */