upstream u-boot with additional patches for our devices/boards: https://lists.denx.de/pipermail/u-boot/2017-March/282789.html (AXP crashes) ; Gbit ethernet patch for some LIME2 revisions ; with SPI flash support
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
 
 
 
 
 
 
u-boot/drivers/spi/tegra20_sflash.c

341 lines
8.6 KiB

/*
* Copyright (c) 2010-2013 NVIDIA Corporation
* With help from the mpc8xxx SPI driver
* With more help from omap3_spi SPI driver
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <malloc.h>
#include <asm/io.h>
#include <asm/gpio.h>
#include <asm/arch/clock.h>
#include <asm/arch/pinmux.h>
#include <asm/arch-tegra/clk_rst.h>
#include <asm/arch-tegra20/tegra20_sflash.h>
#include <spi.h>
#include <fdtdec.h>
DECLARE_GLOBAL_DATA_PTR;
#define SPI_CMD_GO (1 << 30)
#define SPI_CMD_ACTIVE_SCLK_SHIFT 26
#define SPI_CMD_ACTIVE_SCLK_MASK (3 << SPI_CMD_ACTIVE_SCLK_SHIFT)
#define SPI_CMD_CK_SDA (1 << 21)
#define SPI_CMD_ACTIVE_SDA_SHIFT 18
#define SPI_CMD_ACTIVE_SDA_MASK (3 << SPI_CMD_ACTIVE_SDA_SHIFT)
#define SPI_CMD_CS_POL (1 << 16)
#define SPI_CMD_TXEN (1 << 15)
#define SPI_CMD_RXEN (1 << 14)
#define SPI_CMD_CS_VAL (1 << 13)
#define SPI_CMD_CS_SOFT (1 << 12)
#define SPI_CMD_CS_DELAY (1 << 9)
#define SPI_CMD_CS3_EN (1 << 8)
#define SPI_CMD_CS2_EN (1 << 7)
#define SPI_CMD_CS1_EN (1 << 6)
#define SPI_CMD_CS0_EN (1 << 5)
#define SPI_CMD_BIT_LENGTH (1 << 4)
#define SPI_CMD_BIT_LENGTH_MASK 0x0000001F
#define SPI_STAT_BSY (1 << 31)
#define SPI_STAT_RDY (1 << 30)
#define SPI_STAT_RXF_FLUSH (1 << 29)
#define SPI_STAT_TXF_FLUSH (1 << 28)
#define SPI_STAT_RXF_UNR (1 << 27)
#define SPI_STAT_TXF_OVF (1 << 26)
#define SPI_STAT_RXF_EMPTY (1 << 25)
#define SPI_STAT_RXF_FULL (1 << 24)
#define SPI_STAT_TXF_EMPTY (1 << 23)
#define SPI_STAT_TXF_FULL (1 << 22)
#define SPI_STAT_SEL_TXRX_N (1 << 16)
#define SPI_STAT_CUR_BLKCNT (1 << 15)
#define SPI_TIMEOUT 1000
#define TEGRA_SPI_MAX_FREQ 52000000
struct spi_regs {
u32 command; /* SPI_COMMAND_0 register */
u32 status; /* SPI_STATUS_0 register */
u32 rx_cmp; /* SPI_RX_CMP_0 register */
u32 dma_ctl; /* SPI_DMA_CTL_0 register */
u32 tx_fifo; /* SPI_TX_FIFO_0 register */
u32 rsvd[3]; /* offsets 0x14 to 0x1F reserved */
u32 rx_fifo; /* SPI_RX_FIFO_0 register */
};
struct tegra_spi_ctrl {
struct spi_regs *regs;
unsigned int freq;
unsigned int mode;
int periph_id;
int valid;
};
struct tegra_spi_slave {
struct spi_slave slave;
struct tegra_spi_ctrl *ctrl;
};
/* tegra20 only supports one SFLASH controller */
static struct tegra_spi_ctrl spi_ctrls[1];
static inline struct tegra_spi_slave *to_tegra_spi(struct spi_slave *slave)
{
return container_of(slave, struct tegra_spi_slave, slave);
}
int tegra20_spi_cs_is_valid(unsigned int bus, unsigned int cs)
{
/* Tegra20 SPI-Flash - only 1 device ('bus/cs') */
if (bus != 0 || cs != 0)
return 0;
else
return 1;
}
struct spi_slave *tegra20_spi_setup_slave(unsigned int bus, unsigned int cs,
unsigned int max_hz, unsigned int mode)
{
struct tegra_spi_slave *spi;
if (!spi_cs_is_valid(bus, cs)) {
printf("SPI error: unsupported bus %d / chip select %d\n",
bus, cs);
return NULL;
}
if (max_hz > TEGRA_SPI_MAX_FREQ) {
printf("SPI error: unsupported frequency %d Hz. Max frequency"
" is %d Hz\n", max_hz, TEGRA_SPI_MAX_FREQ);
return NULL;
}
spi = spi_alloc_slave(struct tegra_spi_slave, bus, cs);
if (!spi) {
printf("SPI error: malloc of SPI structure failed\n");
return NULL;
}
spi->ctrl = &spi_ctrls[bus];
if (!spi->ctrl) {
printf("SPI error: could not find controller for bus %d\n",
bus);
return NULL;
}
if (max_hz < spi->ctrl->freq) {
debug("%s: limiting frequency from %u to %u\n", __func__,
spi->ctrl->freq, max_hz);
spi->ctrl->freq = max_hz;
}
spi->ctrl->mode = mode;
return &spi->slave;
}
void tegra20_spi_free_slave(struct spi_slave *slave)
{
struct tegra_spi_slave *spi = to_tegra_spi(slave);
free(spi);
}
int tegra20_spi_init(int *node_list, int count)
{
struct tegra_spi_ctrl *ctrl;
int i;
int node = 0;
int found = 0;
for (i = 0; i < count; i++) {
ctrl = &spi_ctrls[i];
node = node_list[i];
ctrl->regs = (struct spi_regs *)fdtdec_get_addr(gd->fdt_blob,
node, "reg");
if ((fdt_addr_t)ctrl->regs == FDT_ADDR_T_NONE) {
debug("%s: no slink register found\n", __func__);
continue;
}
ctrl->freq = fdtdec_get_int(gd->fdt_blob, node,
"spi-max-frequency", 0);
if (!ctrl->freq) {
debug("%s: no slink max frequency found\n", __func__);
continue;
}
ctrl->periph_id = clock_decode_periph_id(gd->fdt_blob, node);
if (ctrl->periph_id == PERIPH_ID_NONE) {
debug("%s: could not decode periph id\n", __func__);
continue;
}
ctrl->valid = 1;
found = 1;
debug("%s: found controller at %p, freq = %u, periph_id = %d\n",
__func__, ctrl->regs, ctrl->freq, ctrl->periph_id);
}
return !found;
}
int tegra20_spi_claim_bus(struct spi_slave *slave)
{
struct tegra_spi_slave *spi = to_tegra_spi(slave);
struct spi_regs *regs = spi->ctrl->regs;
u32 reg;
/* Change SPI clock to correct frequency, PLLP_OUT0 source */
clock_start_periph_pll(spi->ctrl->periph_id, CLOCK_ID_PERIPH,
spi->ctrl->freq);
/* Clear stale status here */
reg = SPI_STAT_RDY | SPI_STAT_RXF_FLUSH | SPI_STAT_TXF_FLUSH | \
SPI_STAT_RXF_UNR | SPI_STAT_TXF_OVF;
writel(reg, &regs->status);
debug("%s: STATUS = %08x\n", __func__, readl(&regs->status));
/*
* Use sw-controlled CS, so we can clock in data after ReadID, etc.
*/
reg = (spi->ctrl->mode & 1) << SPI_CMD_ACTIVE_SDA_SHIFT;
if (spi->ctrl->mode & 2)
reg |= 1 << SPI_CMD_ACTIVE_SCLK_SHIFT;
clrsetbits_le32(&regs->command, SPI_CMD_ACTIVE_SCLK_MASK |
SPI_CMD_ACTIVE_SDA_MASK, SPI_CMD_CS_SOFT | reg);
debug("%s: COMMAND = %08x\n", __func__, readl(&regs->command));
/*
* SPI pins on Tegra20 are muxed - change pinmux later due to UART
* issue.
*/
pinmux_set_func(PINGRP_GMD, PMUX_FUNC_SFLASH);
pinmux_tristate_disable(PINGRP_LSPI);
pinmux_set_func(PINGRP_GMC, PMUX_FUNC_SFLASH);
return 0;
}
void tegra20_spi_cs_activate(struct spi_slave *slave)
{
struct tegra_spi_slave *spi = to_tegra_spi(slave);
struct spi_regs *regs = spi->ctrl->regs;
/* CS is negated on Tegra, so drive a 1 to get a 0 */
setbits_le32(&regs->command, SPI_CMD_CS_VAL);
}
void tegra20_spi_cs_deactivate(struct spi_slave *slave)
{
struct tegra_spi_slave *spi = to_tegra_spi(slave);
struct spi_regs *regs = spi->ctrl->regs;
/* CS is negated on Tegra, so drive a 0 to get a 1 */
clrbits_le32(&regs->command, SPI_CMD_CS_VAL);
}
int tegra20_spi_xfer(struct spi_slave *slave, unsigned int bitlen,
const void *data_out, void *data_in, unsigned long flags)
{
struct tegra_spi_slave *spi = to_tegra_spi(slave);
struct spi_regs *regs = spi->ctrl->regs;
u32 reg, tmpdout, tmpdin = 0;
const u8 *dout = data_out;
u8 *din = data_in;
int num_bytes;
int ret;
debug("spi_xfer: slave %u:%u dout %08X din %08X bitlen %u\n",
slave->bus, slave->cs, *(u8 *)dout, *(u8 *)din, bitlen);
if (bitlen % 8)
return -1;
num_bytes = bitlen / 8;
ret = 0;
reg = readl(&regs->status);
writel(reg, &regs->status); /* Clear all SPI events via R/W */
debug("spi_xfer entry: STATUS = %08x\n", reg);
reg = readl(&regs->command);
reg |= SPI_CMD_TXEN | SPI_CMD_RXEN;
writel(reg, &regs->command);
debug("spi_xfer: COMMAND = %08x\n", readl(&regs->command));
if (flags & SPI_XFER_BEGIN)
spi_cs_activate(slave);
/* handle data in 32-bit chunks */
while (num_bytes > 0) {
int bytes;
int is_read = 0;
int tm, i;
tmpdout = 0;
bytes = (num_bytes > 4) ? 4 : num_bytes;
if (dout != NULL) {
for (i = 0; i < bytes; ++i)
tmpdout = (tmpdout << 8) | dout[i];
}
num_bytes -= bytes;
if (dout)
dout += bytes;
clrsetbits_le32(&regs->command, SPI_CMD_BIT_LENGTH_MASK,
bytes * 8 - 1);
writel(tmpdout, &regs->tx_fifo);
setbits_le32(&regs->command, SPI_CMD_GO);
/*
* Wait for SPI transmit FIFO to empty, or to time out.
* The RX FIFO status will be read and cleared last
*/
for (tm = 0, is_read = 0; tm < SPI_TIMEOUT; ++tm) {
u32 status;
status = readl(&regs->status);
/* We can exit when we've had both RX and TX activity */
if (is_read && (status & SPI_STAT_TXF_EMPTY))
break;
if ((status & (SPI_STAT_BSY | SPI_STAT_RDY)) !=
SPI_STAT_RDY)
tm++;
else if (!(status & SPI_STAT_RXF_EMPTY)) {
tmpdin = readl(&regs->rx_fifo);
is_read = 1;
/* swap bytes read in */
if (din != NULL) {
for (i = bytes - 1; i >= 0; --i) {
din[i] = tmpdin & 0xff;
tmpdin >>= 8;
}
din += bytes;
}
}
}
if (tm >= SPI_TIMEOUT)
ret = tm;
/* clear ACK RDY, etc. bits */
writel(readl(&regs->status), &regs->status);
}
if (flags & SPI_XFER_END)
spi_cs_deactivate(slave);
debug("spi_xfer: transfer ended. Value=%08x, status = %08x\n",
tmpdin, readl(&regs->status));
if (ret) {
printf("spi_xfer: timeout during SPI transfer, tm %d\n", ret);
return -1;
}
return 0;
}