Add a README file to help users getting started with the board. Signed-off-by: Diego Dorta <diego.dorta@nxp.com> Reviewed-by: Fabio Estevam <fabio.estevam@nxp.com> Reviewed-by: Peng Fan <peng.fan@nxp.com> Reviewed-by: Jagan Teki <jagan@openedev.com>master
parent
02c2de6eb0
commit
2ffec69b6f
@ -0,0 +1,36 @@ |
|||||||
|
How to use U-Boot on Freescale MX6ULL 14x14 EVK |
||||||
|
---------------------------------------------- |
||||||
|
|
||||||
|
- First make sure you have installed the dtc package (device tree compiler): |
||||||
|
|
||||||
|
$ sudo apt-get install device-tree-compiler |
||||||
|
|
||||||
|
- Build U-Boot for MX6ULL 14x14 EVK: |
||||||
|
|
||||||
|
$ make mrproper |
||||||
|
$ make mx6ull_14x14_evk_defconfig |
||||||
|
$ make |
||||||
|
|
||||||
|
This generates the u-boot-dtb.imx image in the current directory. |
||||||
|
|
||||||
|
- Flash the u-boot-dtb.imx image into the micro SD card: |
||||||
|
|
||||||
|
$ sudo dd if=u-boot-dtb.imx of=/dev/sdb bs=1K seek=1 && sync |
||||||
|
|
||||||
|
- Jumper settings: |
||||||
|
|
||||||
|
SW601: 0 0 1 0 |
||||||
|
Sw602: 1 0 |
||||||
|
|
||||||
|
Where 0 means bottom position and 1 means top position (from the switch label |
||||||
|
numbers reference). |
||||||
|
|
||||||
|
Connect the USB cable between the EVK and the PC for the console. |
||||||
|
(The USB console connector is the one close the push buttons) |
||||||
|
|
||||||
|
Insert the micro SD card in the board, power it up and U-Boot messages should |
||||||
|
come up. |
||||||
|
|
||||||
|
The link for the board: http://www.nxp.com/products/microcontrollers-and- \ |
||||||
|
processors/arm-processors/i.mx-applications-processors/i.mx-6-processors/ \ |
||||||
|
i.mx6qp/evaluation-kit-for-the-i.mx-6ull-applications-processor:MCIMX6ULL-EVK |
Loading…
Reference in new issue