upstream u-boot with additional patches for our devices/boards:
https://lists.denx.de/pipermail/u-boot/2017-March/282789.html (AXP crashes) ;
Gbit ethernet patch for some LIME2 revisions ;
with SPI flash support
You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
Albert ARIBAUD
85b8c5c4bf
|
11 years ago | |
|---|---|---|
| .. | ||
| Makefile | 11 years ago | |
| README | 11 years ago | |
| wandboard.c | 11 years ago | |
README
U-Boot for Wandboard
--------------------
This file contains information for the port of U-Boot to the Wandboard.
Wandboard is a development board that has three variants based on the following
SoCs: mx6 quad, mx6 dual lite and mx6 solo.
For more details about Wandboard, please refer to:
http://www.wandboard.org/
Building U-boot for Wandboard
-----------------------------
To build U-Boot for the Wandboard Dual Lite version:
$ make wandboard_dl_config
$ make
To build U-Boot for the Wandboard Solo version:
$ make wandboard_solo_config
$ make
To build U-Boot for the Wandboard Quad version:
$ make wandboard_quad_config
$ make
Flashing U-boot into the SD card
--------------------------------
- After the 'make' command completes, the generated 'u-boot.imx' binary must be
flashed into the SD card;
$ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=512 seek=2; sync
(Note - the SD card node may vary, so adjust this as needed).
- Insert the SD card into the slot located in the bottom of the board (same side
as the mx6 processor)
- Connect the serial cable to the host PC
- Power up the board and U-boot messages will appear in the serial console.