upstream u-boot with additional patches for our devices/boards: https://lists.denx.de/pipermail/u-boot/2017-March/282789.html (AXP crashes) ; Gbit ethernet patch for some LIME2 revisions ; with SPI flash support
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
u-boot/doc/driver-model/i2c-howto.txt

55 lines
2.1 KiB

How to port a serial driver to driver model
===========================================
Over half of the I2C drivers have been converted as at November 2016. These
ones remain:
adi_i2c
davinci_i2c
fti2c010
ihs_i2c
kona_i2c
lpc32xx_i2c
pca9564_i2c
ppc4xx_i2c
rcar_i2c
sh_i2c
soft_i2c
zynq_i2c
The deadline for this work is the end of June 2017. If no one steps
forward to convert these, at some point there may come a patch to remove them!
Here is a suggested approach for converting your I2C driver over to driver
model. Please feel free to update this file with your ideas and suggestions.
- #ifdef out all your own I2C driver code (#ifndef CONFIG_DM_I2C)
- Define CONFIG_DM_I2C for your board, vendor or architecture
- If the board does not already use driver model, you need CONFIG_DM also
- Your board should then build, but will not work fully since there will be
no I2C driver
- Add the U_BOOT_DRIVER piece at the end (e.g. copy tegra_i2c.c for example)
- Add a private struct for the driver data - avoid using static variables
- Implement each of the driver methods, perhaps by calling your old methods
- You may need to adjust the function parameters so that the old and new
implementations can share most of the existing code
- If you convert all existing users of the driver, remove the pre-driver-model
code
In terms of patches a conversion series typically has these patches:
- clean up / prepare the driver for conversion
- add driver model code
- convert at least one existing board to use driver model serial
- (if no boards remain that don't use driver model) remove the old code
This may be a good time to move your board to use device tree also. Mostly
this involves these steps:
- define CONFIG_OF_CONTROL and CONFIG_OF_SEPARATE
- add your device tree files to arch/<arch>/dts
- update the Makefile there
- Add stdout-path to your /chosen device tree node if it is not already there
- build and get u-boot-dtb.bin so you can test it
- Your drivers can now use device tree
- For device tree in SPL, define CONFIG_SPL_OF_CONTROL