upstream u-boot with additional patches for our devices/boards: https://lists.denx.de/pipermail/u-boot/2017-March/282789.html (AXP crashes) ; Gbit ethernet patch for some LIME2 revisions ; with SPI flash support
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
u-boot/board/freescale/m5249evb/m5249evb.c

94 lines
2.4 KiB

/*
* (C) Copyright 2004
* Wolfgang Denk, DENX Software Engineering, wd@denx.de.
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <command.h>
#include <malloc.h>
#include <asm/immap.h>
int checkboard (void) {
ulong val;
uchar val8;
puts ("Board: ");
puts("Freescale M5249EVB");
val8 = ((uchar)~((uchar)mbar2_readLong(MCFSIM_GPIO1_READ) >> 4)) & 0xf;
printf(" (Switch=%1X)\n", val8);
/*
* Set LED on
*/
val = mbar2_readLong(MCFSIM_GPIO1_OUT) & ~CONFIG_SYS_GPIO1_LED;
mbar2_writeLong(MCFSIM_GPIO1_OUT, val); /* Set LED on */
return 0;
};
phys_size_t initdram (int board_type) {
unsigned long junk = 0xa5a59696;
/*
* Note:
* RC = ([(RefreshTime/#rows) / (1/BusClk)] / 16) - 1
*/
#ifdef CONFIG_SYS_FAST_CLK
/*
* Busclk=70MHz, RefreshTime=64ms, #rows=4096 (4K)
* SO=1, NAM=0, COC=0, RTIM=01 (6clk refresh), RC=39
*/
mbar_writeShort(MCFSIM_DCR, 0x8239);
#elif CONFIG_SYS_PLL_BYPASS
/*
* Busclk=5.6448MHz, RefreshTime=64ms, #rows=8192 (8K)
* SO=1, NAM=0, COC=0, RTIM=01 (6clk refresh), RC=02
*/
mbar_writeShort(MCFSIM_DCR, 0x8202);
#else
/*
* Busclk=36MHz, RefreshTime=64ms, #rows=4096 (4K)
* SO=1, NAM=0, COC=0, RTIM=01 (6clk refresh), RC=22 (562 bus clock cycles)
*/
mbar_writeShort(MCFSIM_DCR, 0x8222);
#endif
/*
* SDRAM starts at 0x0000_0000, CASL=10, CBM=010, PS=10 (16bit port),
* PM=1 (continuous page mode)
*/
/* RE=0 (keep auto-refresh disabled while setting up registers) */
mbar_writeLong(MCFSIM_DACR0, 0x00003324);
/* BAM=007c (bits 22,21 are bank selects; 256kB blocks) */
mbar_writeLong(MCFSIM_DMR0, 0x01fc0001);
/** Precharge sequence **/
mbar_writeLong(MCFSIM_DACR0, 0x0000332c); /* Set DACR0[IP] (bit 3) */
*((volatile unsigned long *) 0x00) = junk; /* write to a memory location to init. precharge */
udelay(0x10); /* Allow several Precharge cycles */
/** Refresh Sequence **/
mbar_writeLong(MCFSIM_DACR0, 0x0000b324); /* Enable the refresh bit, DACR0[RE] (bit 15) */
udelay(0x7d0); /* Allow gobs of refresh cycles */
/** Mode Register initialization **/
mbar_writeLong(MCFSIM_DACR0, 0x0000b364); /* Enable DACR0[IMRS] (bit 6); RE remains enabled */
*((volatile unsigned long *) 0x800) = junk; /* Access RAM to initialize the mode register */
return CONFIG_SYS_SDRAM_SIZE * 1024 * 1024;
};
int testdram (void) {
/* TODO: XXX XXX XXX */
printf ("DRAM test not implemented!\n");
return (0);
}