sf: always read 5 bytes for the idcode

Some SPI flash drivers like to have extended id information available
(like the spansion flash), so rather than making it re-issue the ID cmd
to get at the last 2 bytes, have the common code read 5 bytes rather than
just 3.  This also matches the Linux behavior where it always reads 5 id
bytes from all flashes.

Signed-off-by: Mike Frysinger <vapier@gentoo.org>
Acked-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
CC: Mingkai Hu <Mingkai.hu@freescale.com>

drivers/mtd/spi/spansion.c

@@ -310,15 +310,9 @@ struct spi_flash *spi_flash_probe_spansion(struct spi_slave *spi, u8 *idcode)
 	struct spansion_spi_flash *spsn;
 	unsigned int i;
 	unsigned short jedec, ext_jedec;
-	int ret;
-	u8 id[5] = {0};
-
-	ret = spi_flash_cmd(spi, CMD_READ_ID, id, sizeof(id));
-	if (ret)
-		return NULL;
 
-	jedec = id[1] << 8 | id[2];
+	jedec = idcode[1] << 8 | idcode[2];
-	ext_jedec = id[3] << 8 | id[4];
+	ext_jedec = idcode[3] << 8 | idcode[4];
 
 	for (i = 0; i < ARRAY_SIZE(spansion_spi_flash_table); i++) {
 		params = &spansion_spi_flash_table[i];

drivers/mtd/spi/spi_flash.c

@@ -101,7 +101,7 @@ struct spi_flash *spi_flash_probe(unsigned int bus, unsigned int cs,
 	struct spi_slave *spi;
 	struct spi_flash *flash;
 	int ret;
-	u8 idcode[3];
+	u8 idcode[5];
 
 	spi = spi_setup_slave(bus, cs, max_hz, spi_mode);
 	if (!spi) {
@@ -120,8 +120,8 @@ struct spi_flash *spi_flash_probe(unsigned int bus, unsigned int cs,
 	if (ret)
 		goto err_read_id;
 
-	debug("SF: Got idcode %02x %02x %02x\n", idcode[0],
+	debug("SF: Got idcode %02x %02x %02x %02x %02x\n", idcode[0],
-			idcode[1], idcode[2]);
+			idcode[1], idcode[2], idcode[3], idcode[4]);
 
 	switch (idcode[0]) {
 #ifdef CONFIG_SPI_FLASH_SPANSION