This patch enables parsing mipi data from device tree. Non device tree case is still supported. Signed-off-by: Piotr Wilczek <p.wilczek@samsung.com> Signed-off-by: Kyungmin Park <kyungmin.park@samsung.com> Signed-off-by: Minkyu Kang <mk7.kang@samsung.com>master
parent
b8dfcdb7d3
commit
de461c526e
@ -0,0 +1,82 @@ |
|||||||
|
Exynos MIPI-DSIM Controller |
||||||
|
========================= |
||||||
|
|
||||||
|
Required properties: |
||||||
|
SOC specific: |
||||||
|
compatible: should be "samsung,exynos-mipi-dsi" |
||||||
|
reg: Base address of MIPI-DSIM IP. |
||||||
|
|
||||||
|
Board specific: |
||||||
|
samsung,dsim-config-e-interface: interface to be used (RGB interface |
||||||
|
for main display or CPU interface for main or sub display). |
||||||
|
samsung,dsim-config-e-virtual-ch: virtual channel number that main |
||||||
|
or sub display uses. |
||||||
|
samsung,dsim-config-e-pixel-format: pixel stream format for main |
||||||
|
or sub display. |
||||||
|
samsung,dsim-config-e-burst-mode: selects Burst mode in Video mode. |
||||||
|
in Non-burst mode, RGB data area is filled with RGB data and |
||||||
|
NULL packets, according to input bandwidth of RGB interface. |
||||||
|
samsung,dsim-config-e-no-data-lane: data lane count used by Master. |
||||||
|
samsung,dsim-config-e-byte-clk: select byte clock source. |
||||||
|
It must be DSIM_PLL_OUT_DIV8. |
||||||
|
DSIM_EXT_CLK_DIV8 and DSIM_EXT_CLK_BYPASSS are not supported. |
||||||
|
samsung,dsim-config-hfp: HFP disable mode. |
||||||
|
If set, DSI master ignores HFP area in VIDEO mode. |
||||||
|
In command mode, this variable is ignored. |
||||||
|
samsung,dsim-config-p: P value for PMS setting. |
||||||
|
samsung,dsim-config-m: M value for PMS setting. |
||||||
|
samsung,dsim-config-s: S value for PMS setting. |
||||||
|
samsung,dsim-config-pll-stable-time: the PLL Timer for stability |
||||||
|
of the ganerated clock. |
||||||
|
samsung,dsim-config-esc-clk: escape clock frequency for getting |
||||||
|
the escape clock prescaler value. |
||||||
|
samsung,dsim-config-stop-holding-cnt: the interval value between |
||||||
|
transmitting read packet (or write "set_tear_on" command) |
||||||
|
and BTA request. After transmitting read packet or write |
||||||
|
"set_tear_on" command, BTA requests to D-PHY automatically. |
||||||
|
This counter value specifies the interval between them. |
||||||
|
samsung,dsim-config-bta-timeout: the timer for BTA. This register |
||||||
|
specifies time out from BTA request to change the direction |
||||||
|
with respect to Tx escape clock. |
||||||
|
samsung,dsim-config-rx-timeout: the timer for LP Rx mode timeout. |
||||||
|
this register specifies time out on how long RxValid deasserts, |
||||||
|
after RxLpdt asserts with respect to Tx escape clock. |
||||||
|
- RxValid specifies Rx data valid indicator. |
||||||
|
- RxLpdt specifies an indicator that D-PHY is under RxLpdt mode |
||||||
|
- RxValid and RxLpdt specifies signal from D-PHY. |
||||||
|
samsung,dsim-device-name: name of the device. |
||||||
|
samsung,dsim-device-id: unique device id. |
||||||
|
samsung,dsim-device-bus_id: bus id for identifing connected bus |
||||||
|
and this bus id should be same as id of mipi_dsim_device. |
||||||
|
|
||||||
|
Optional properties: |
||||||
|
samsung,dsim-device-reverse-panel: reverse panel. |
||||||
|
|
||||||
|
Example: |
||||||
|
mipidsi@11c80000 { |
||||||
|
compatible = "samsung,exynos-mipi-dsi"; |
||||||
|
reg = <0x11c80000 0x5c>; |
||||||
|
|
||||||
|
samsung,dsim-config-e-interface = <1>; |
||||||
|
samsung,dsim-config-e-virtual-ch = <0>; |
||||||
|
samsung,dsim-config-e-pixel-format = <7>; |
||||||
|
samsung,dsim-config-e-burst-mode = <1>; |
||||||
|
samsung,dsim-config-e-no-data-lane = <3>; |
||||||
|
samsung,dsim-config-e-byte-clk = <0>; |
||||||
|
samsung,dsim-config-hfp = <1>; |
||||||
|
|
||||||
|
samsung,dsim-config-p = <3>; |
||||||
|
samsung,dsim-config-m = <120>; |
||||||
|
samsung,dsim-config-s = <1>; |
||||||
|
|
||||||
|
samsung,dsim-config-pll-stable-time = <500>; |
||||||
|
samsung,dsim-config-esc-clk = <20000000>; |
||||||
|
samsung,dsim-config-stop-holding-cnt = <0x7ff>; |
||||||
|
samsung,dsim-config-bta-timeout = <0xff>; |
||||||
|
samsung,dsim-config-rx-timeout = <0xffff>; |
||||||
|
|
||||||
|
samsung,dsim-device-id = <0xffffffff>; |
||||||
|
samsung,dsim-device-bus-id = <0>; |
||||||
|
|
||||||
|
samsung,dsim-device-reverse-panel = <1>; |
||||||
|
}; |
Loading…
Reference in new issue