upstream u-boot with additional patches for our devices/boards: https://lists.denx.de/pipermail/u-boot/2017-March/282789.html (AXP crashes) ; Gbit ethernet patch for some LIME2 revisions ; with SPI flash support
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
 
 
 
 
 
 
u-boot/doc/device-tree-bindings/misc/intel-lpc.txt

64 lines
1.8 KiB

Intel LPC Device Binding
========================
The device tree node which describes the operation of the Intel Low Pin
Count device is as follows:
Required properties :
- compatible = "intel,lpc"
- intel,alt-gp-smi-enable : Enable SMI sources. This cell is written to the
ALT_GP_SMI_EN register
- intel,gen-dec : Specifies the values for the gen-dec registers. Up to four
cell pairs can be provided - the first of each pair is the base address and
the second is the size. These are written into the GENx_DEC registers of
the LPC device
- intel,gpi-routing : Specifies the GPI routing. There are 16 cells, valid
values are:
0 No effect (default)
1 SMI# (if corresponding ALT_GPI_SMI_EN bit is also set)
2 SCI (if corresponding GPIO_EN bit is also set)
- intel,pirq-routing : Speciffies the routing IRQ number for each of PIRQA-H,
one cell for each.
0x00 - 0000 = Reserved
0x01 - 0001 = Reserved
0x02 - 0010 = Reserved
0x03 - 0011 = IRQ3
0x04 - 0100 = IRQ4
0x05 - 0101 = IRQ5
0x06 - 0110 = IRQ6
0x07 - 0111 = IRQ7
0x08 - 1000 = Reserved
0x09 - 1001 = IRQ9
0x0A - 1010 = IRQ10
0x0B - 1011 = IRQ11
0x0C - 1100 = IRQ12
0x0D - 1101 = Reserved
0x0E - 1110 = IRQ14
0x0F - 1111 = IRQ15
PIRQ[n]_ROUT[7] - PIRQ Routing Control
0x80 - The PIRQ is not routed.
Example
-------
lpc {
compatible = "intel,lpc";
#address-cells = <1>;
#size-cells = <1>;
intel,gen-dec = <0x800 0xfc 0x900 0xfc>;
intel,pirq-routing = <0x8b 0x8a 0x8b 0x8b
0x80 0x80 0x80 0x80>;
/*
* GPI routing
* 0 No effect (default)
* 1 SMI# (if corresponding ALT_GPI_SMI_EN bit is
* also set)
* 2 SCI (if corresponding GPIO_EN bit is also set)
*/
intel,gpi-routing = <0 0 0 0 0 0 0 2
1 0 0 0 0 0 0 0>;
/* Enable EC SMI source */
intel,alt-gp-smi-enable = <0x0100>;
};